6.7. Light Over the DoorThese are readily available in N Scale, but not Z, so I had to make mine from scratch. |
||
|
||
I started with a piece of brass wire bent to shape. |
||
I soldered one terminal of a warm white 0402 SMD LED to the end of the wire. |
||
Then I soldered a piece of very fine wire to the other terminal of the LED. |
||
I carefully bonded the fine wire to the side of the arm with super glue. |
||
I then attached the smallest Ngineering lampshade they make. |
||
This styrene escutcheon may be one of the tiniest parts I've ever fabricated. |
||
The finished lamp was painted and ready to install over the door. Here it is compared to a Z Scale figure. |
||
ReturnCopyright © 2017-2020 by David K. Smith. All Rights Reserved | Site Map |